Energicwave

EMAT 150W

Profesionálna elektrická vyhrievacia rohož pod podlahu — 150W/m², samolepiaca sklolaminátová sieťka, 7-žilový kábel, krytie IP68, záruka 25 rokov

EMAT 150W Heating Mat
150W/m²

Výkon 150W/m²

3.6mm

3.6mm

25years

Warranty

IP68

Waterproof

Ultra-Thin Design

3.6mm thin.
No floor raise needed.

Thinner than a credit card edge. The EMAT installs directly under your tiles without raising the floor level — perfect for renovations where every millimeter counts.

EMAT cable thickness compared to credit card

Engineered for Durability

7 strands of resilience.

Unlike single-strand cables that fail completely when damaged, our 7-strand construction keeps heating even if one strand breaks. Better heat distribution. Greater fault tolerance. Built to last 50+ years.

7-strand wire cross section
🔧

Crack Resistant

Flexible multi-strand design resists bending and stretching damage

🌡️

Even Heat

Increased surface area eliminates hot spots across the entire mat

🛡️

Fault Tolerant

System continues working even if a single strand fails

Invisible Integration

Disappears into your floor.

Concrete. Mat. Adhesive. Tile. Four layers, zero compromise. The EMAT sits between your subfloor and tiles — completely invisible, completely silent.

Floor cross-section showing heating mat layers
01

Concrete Subfloor

02

EMAT Heating Mat

03

Tile Adhesive

04

Ceramic Tile

IP68 waterproof cable with water droplets

IP68 Certified

Bathrooms. Wet rooms. No problem.

IP68 rated — the highest level of dust and water protection. Install with confidence in bathrooms, kitchens, and wet rooms. The polyamide-teflon insulation repels moisture completely.

Self-Adhesive Backing

Peel. Stick. Done.

No clips, no staples, no special tools. The self-adhesive fiberglass mesh sticks directly to your subfloor. Cut the mesh to navigate corners — the cable stays intact.

Professional installing EMAT heating mat
1

Prepare

Clean, level subfloor. Apply primer if needed.

2

Roll & Stick

Unroll the mat, press the self-adhesive mesh down. Cut mesh at turns.

3

Tile Over

Apply tile adhesive directly over the mat. Lay tiles as normal.

Technical Specifications

Power Density150 W/m²
Cable Thickness3.6 mm
Mat Width50 cm
Available Sizes0.5 – 14 m²
Wire Construction7-strand heating wire
InsulationPolyamide-Teflon
BackingSelf-adhesive fiberglass mesh
Waterproof RatingIP68
ConnectionSingle-sided, 2m power cable
Compatible FloorsCeramic, porcelain, stone
Warranty25 years

Ready to feel the warmth?

Available in sizes from 0.5 m² to 14 m². Free shipping on orders over €20.